Lentequip SafeTap, Anton Bauer D-Tap connector, met ingebouwde zekering, 24" (60cm) openlead

€ 127,50

€ 105,37 exclusief BTW
Artikelnummer
STapPT24
Voorraad
Per direct


Omschrijving

IOS COMPATIBLE USB CHARGER

Have you ever been on set running desperately low on power for your iPhone or iPad?  Sure you have. Yet surrounding you are vast amounts of camera batteries that you can not connect to.

iOS compatible USB charger featuring our new SafeTap connector  We've created a ultra high efficient power supply which will enable you to fast charge all your devices in no time. This small gadget will allow you to connect to any input voltage ranging from 8-18 volts  and will output a highly regulated 5V with a maximum iOS current of 2 Amps meaning a fast charge. The input of the charger is SafeTap protected and fused while the output is not only short circuit protected, but also incorporates a safety clamping circuit to ensure that your devices remain safe. A green LED indicates that the output voltage is present and can be seen through the translucent enclosure which measures only 60mm(l) x 35mm(w) x 15mm(h).  The flexible cable connected to the SafeTap is 20 cm long. 

Use this device to charge your iOS or 5V compatible devices or even your RED remote! Even use it to power your GoPro from much higher capacity batteries.

Revolutionary patented protection for all your P or D Tap powered accessories. Built-in intelligence monitors for reverse polarity, over/under voltage, short circuits and prevents battery deep discharge. Now RED DIGITAL APPROVED!

UPGRADE YOUR CONNECTION TODAY.

  • Stop using the P/D-Tap connectors on your expensive state-of-the-art equipment. Why ? (READ THIS TESTIMONIAL NOW!)  One reverse polarity insertion and you'll be happy you did! Reverse polarity insertions are among the leading causes of P-Tap'ed equipment failure. The SafeTap detects this deadly condition and never enables the output to the device it is connected to. Lentequip’s SafeTap connector is a complete reinvention of the existing PowerTap by Anton Bauer and similar D-Taps, featuring a first ever computer controlled connector. Built-in intelligence monitors for reverse polarity, over/under voltage and short circuits so you'll never need to worry about damaging your expensive equipment due to any of these hazardous conditions! The reverse polarity protection alone will save rental houses and owner operators costly repairs with unnecessary production downtime and lost revenue.

  • The SafeTap provides user feedback via its multicoloured LED. 8 amps continuous may be drawn from the connector but may have to be slightly de-rated based on ambient temperature, lead length and cross section cable used. A sleep mode is activated at 10V, indicated by a blue light, to guard your battery against deep discharge. This feature prevents your costly power source from draining into the damaging extreme low voltage zone should you inadvertently leave a powered accessory unattended.

  • The SafeTap was also designed with easy and speedy assembly in mind. Knock-out sections on the left and right side of the housing allow for easy cable exit.  Cable strain relief is accomplished via a simple yet effective tie wrap which resists considerable pull-out forces thanks to friction features built into the lower shell housing.

     Each SafeTap comes with instructions

The SafeTap is patented in the USA, 10014632 and in Canada, 2,889,893. Other countries pending.

Each SafeTap is 100% tested and guaranteed for one yea

Technische specificaties
Merk Lentequip
Produkt D-Tap zekering
Recensies
Geef je mening en schrijf als eerste een review.
Wat is uw beoordeling voor dit artikel